Material About Us Products Technical Center News TruGrain Owner Contact
What is TruGrain Characteristics Color Concept

Color Concept

In its raw produced form, TruGrain has a natural, warm color. AquaSurTech and Resysta offer a variety of surface finishes in a range of colors.


TruStainTM creates a molecular bond to any TruGrain® made with Resysta® based product. This eliminates the potential for inter layer failures common with more traditional stain/clear coat systems. By integrating heat reflective pigments into AquaSurTech’s proprietary resin, both color and protection are incorporated into a single simple to apply layer. The heat reflective properties of the pigments reduce the temperature of the surface and retains color longer than conventional pigments.

TruStainTM is a water based, odorless, ultra-low VOC designed to bond to composites, fibreglass and PVC... so you can match your project with other elements such as trim and windows and doors (fibreglass or steel).

Features / Benefits

  • TruStain is a single component - the molecular bond eliminates the potential for inter layer failures common with stain/clear coat systems
  • Brushable or Sprayable (2 viscosities are available)
  • Coverage is approximately 250 square feet per gallon
    ( 6.5 meters squared per litre )
  • Fast Air Drying - 20 minutes for flash, dry in 2 hours
  • Heat Reflective - lower temperatures and less fade
    (delta E of less than 1 after 3,000 hours accelerated
    weathering with Xenon Arc - ASTM G155 )
  • High flexibility resin results in excellent wear and
    impact resistance - TruGrain can be cut after finishing
  • Meets AAMA 615-13 test standard
  • Environmental performance is market leading - 20 g/litre
    VOC, lead , chromate, isocyanate and NMP FREE
  • Wear Tested (ASTM D4060-14, Standard Test Methods
    for Abrasion Resistance of Organic Coatings by the
    Taber Abraser )
  • Odorless application with water clean up
Warranty: 15 years for Siding


Simple on-site application by Brush or Spray OR factory applied via Flow Coating or Spraying AquaSurTech can connect you with a local certified applicator if you require application services.         

Stock Colors
Additional custom colors are available.

TruStain Application Instructions                                                                                                
Resysta offers over 20 surface finishes, including a range of natural wood tones as well as many bold designer colors. Because Resysta is water resistant and highly UV resistant, the color will remain vibrant. A special 2K varnish, which was specifically developed for TruGrain products.

Resysta 2K Sealer RFS is a diluted, transparent two component polyurethane sealer for in- and outdoor use.

This two component (2K) sealer is one part varnish (component A) to which a hardener is added (component B). After drying, Resysta 2K Sealer RFS covers the surface with a highly resilient, transparent varnish that enormously increases the mechanical and chemical resistance of the treated area. The sealer protects from stains caused by grease, oils or other extraneous influences.

From natural glazes to opaque colors, Resysta offers incredible design flexibility. Special Color requests are also welcome. Imagination is the only limit when designing with Resysta!

Standard Colors

Color Range

Resysta Finishes USA 2015
Resysta Surface Treatment USA 2015
Resysta Care and Cleaning 2015
Resysta Application Instruction RFS

Resysta Application Instruction FVG
Resysta Finish Warranty

P: 866.423.2385

7451 Indiana 62
Mt Vernon, IN 47620

materialabout usproductstechnical centernewsgallerytrugrain ownercontact us

© 2014 TruGrain. All Rights Reserved.